factory seat belts
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

factory seat belts



The seat belts were bolted through the floor pan . They were backed by some very large washers too.The colour of the webbing seems to be the hardest part of the puzzle to find out.
Regards
Dave.
----- Original Message -----
From: W Bell
Sent: Wednesday, April 21, 2004 7:21 AM
Subject: IML: factory seat belts

I might be wrong, but I suspect seat belts were optional until they became standard in the early '60s.  After the big safety buzz that Ford started in '56, a manufacturer would have had to be a little dense to not have padded dashes and seat belts as optional equipment.
 
Key thing would be to determine if there were seat belt anchors in the floorpan.  Basically, that might be a reinforced area or segment of an area behind the seats, near the outer rocker panel area and on each side of the driveshaft tunnel.  Otherwise, you'd need someone to make a reinforcment piece with an appropriate size nut welded in the middle of it, for the seat belt bolt to screw into from the top side and get that tack welded to the underside of the floorpan.
 
I kind of suspect that many of the earlier seat belts would be similar to what the add-on units or "replacement" lap belts of today might be.  The thicker webbing came in more toward the 1964 or 1965 time frame, again, if I remember correctly.
 
Enjoy!
W Bell


Home Back to the Home of the Forward Look Network


Copyright © The Forward Look Network. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
This site contains affiliate links for which we may be compensated.