Subject: IML: '68 side marker issue Reply-To: mailing-list@xxxxxxxxxxxxxxxx I'm going through the annual humbug of trying to get my '68 LeBaron through a safety inspection. I spent an hour today trying to get the bulb out of the side marker built into the front bumper. They're obviously set up differently than the rear marker lights, which simply plug in and out. I crawled underneath and spotted threads on the metal plug and finally managed with a pliers to get it to turn ... but then it just turned and turned and turned. So then I figured it had to pull it straight out somehow, but it wouldn't pull and I didn't want to break it. I couldn't spot any clips or anything that would suggest how it's secured in there. This isn't the biggest deal in the world but any direction would be appreciated. Aloha, Jim Kelly Honolulu '68 LeBaron Jim, I have had these out on Lucille, as the grounds were not working - they ground to the body through the casting of the light housing and the spring steel clip that holds them in. Take a stiff brush and clean the heck out of the backside around the point of entry through the body, then get a good light and take a look. The cast (zinc?) light housing had a flat metal slip-on clip, much like those holding rubber brake lines into those star brackets on the frame on GM cars and trucks. You should be able to tap the clip off and then the light comes out from the outside. It's a real neck-strainer to see up in there, though! Kate Justet Triplett Kate's Custom Gunleather Monroe, Washington Proud mother of a soldier and owner of ----------------- http://www.imperialclub.com ----------------- This message was sent to you by the Imperial Mailing List. Please reply to mailing-list@xxxxxxxxxxxxxxxx and your response will be shared with everyone. Private messages (and attachments) for the Administrators should be sent to webmaster@xxxxxxxxxxxxxxxx To UN-SUBSCRIBE, go to http://imperialclub.com/unsubscribe.htm