[FWDLK] steering linkage arm

["Deane Allinson" <deane.allinson@xxxxxxxxxxxxx>]

I'm beginning to tear down my front end to replace tie rod ends, ball
joints etc.
and have a question about the ends on my steering linkage arm. The ends
seem
O.K. except that there is little or no grease in them or it's just
solidified. An
acquaintance suggested that I just install a grease fitting in them
(there is not
one now) and put them back in place. Is this wise advice or trouble
later? A
new arm from a catalog was $230 plus exchange and grease fitting is 50
(hey
there is no cents key on my keyboard) cents. It seems like a no brainer
unless
any of you have a horror story or other advice.
Deane
60Polara