Re: [FWDLK] How do I disconnect trans and remove the 383?

[Jan & Roger van Hoy <vanhilla@xxxxxxxxxxxx>]

But isn't it easier overall to pull the engine and trans as a unit?  I've 
done it that way a number of times and had no problems.

--Roger van Hoy, Washougal, WA, '55 DeSoto, '58 DeSoto, '56 Plymouth, '66 
Plymouth, '41 Dodge

----- Original Message ----- 
From: "Bob Moore" <remoore@xxxxxxxxxxxxx>
To: <L-FORWARDLOOK@xxxxxxxxxxxxx>
Sent: Saturday, February 23, 2008 10:40 AM
Subject: Re: [FWDLK] How do I disconnect trans and remove the 383?


> Hi Lou,
>
> Not too hard as long as you can turn the engine!  The trick is to remove 
> the
> shield at the front of the bell housing and get a long wrench, 5/8" or so 
> up
> between the torque converter and the pan, and remove the ~6 nuts that hold
> the converter to the crank.  Then undo all the bolts from the bellhousing,
> starter and cooling lines, then just slide the engine forward ~1" and your
> free to lift that puppy out!
>
> Have fun,
>
> -Bob
>
> -----Original Message-----
> From: Forward Look Mopar Discussion List
> [mailto:L-FORWARDLOOK@xxxxxxxxxxxxx] On Behalf Of Lou
> Sent: Saturday, February 23, 2008 9:25 AM
> To: L-FORWARDLOOK@xxxxxxxxxxxxx
> Subject: [FWDLK] How do I disconnect trans and remove the 383?
>
> Hi all,
>
> I want to remove the 383 from my '59 Dodge while leaving the TorqueFlite
> in place.   Can it be done ?
>
> As I recall, the crankshaft sticks out the rear of the engine. Does the
> torque converter bolt to the flywheel or a flange, or is it a splined
> shaft and everything just slides apart?  I have not yet removed the
> bottom cover to look up in there...just trying to learn in advance, and
> my shop manual ain't here yet.
>
> Also, it looks pretty tight under there. Does the engine have to slide
> forward at all/much to unbolt it from the trans?  looks like the oil pan
> will hit the front cross member after an inch or so, unless it gets
> lifted about 8 inches, which I dont thik is possible.
>
> Any tips would be appreciated.  Meantime I am removing all the
> accessories, intake, unbolting exhaust, etc, etc. in preparation.
>
> Regards,
> Lou
>
> *************************************************************
>
> To unsubscribe or set your subscription options, please go to
> http://lists.psu.edu/cgi-bin/wa?SUBED1=l-forwardlook&A=1
>
> *************************************************************
>
> To unsubscribe or set your subscription options, please go to
> http://lists.psu.edu/cgi-bin/wa?SUBED1=l-forwardlook&A=1

*************************************************************

To unsubscribe or set your subscription options, please go to
http://lists.psu.edu/cgi-bin/wa?SUBED1=l-forwardlook&A=1