Re: [FWDLK] Light my FIRE ?

[Dave Stragand <dave.stragand@xxxxxxxxxxxxxxx>]

Yes, identically.  I did both drums and linings. It cured my grabbing issue instantly.

Second note of obviousness -- don't do it on the car -- remove the parts first..

-Dave

-----Original Message-----
From: Eastern Sierra Adjustment Services <esierraadj@xxxxxxxxxxx>

Date:         Wed, 28 May 2008 13:31:21 
To:L-FORWARDLOOK@xxxxxxxxxxxxx
Subject: [FWDLK] Light my FIRE ?


Would the light-my-fire protocol work on contaminated brake shoe linings?



Dave Stragand wrote:
>
> A great solution to contaminants on brake drums is to set them on
> fire. (Don’t laugh – it works fantastically.)
>
> Spray them heavily with brake cleaner and light them on fire. The
> combination of heat and cleaner even gets oils out of the pores in the
> metal. The temps are still much lower than they get in real use, and
> little if any residue is left behind. An old-timer recommended this
> with my ‘locking-on-first-use” problem on my ’59 DeS.
>
> Note of the obvious – don’t do this indoors.
>
> -Dave
>
> ------------------------------------------------------------------------
>
> *From:* Forward Look Mopar Discussion List
> [mailto:L-FORWARDLOOK@xxxxxxxxxxxxx] *On Behalf Of *John Teske
> *Sent:* Wednesday, May 28, 2008 3:55 PM
> *To:* L-FORWARDLOOK@xxxxxxxxxxxxx
> *Subject:* Re: [FWDLK] Sandblast Brake Drums ?
>
> Ron:
>
> I had my 11 inch drums sand blasted and power coated. During each of
> these processes, the contact surface was protected with masking tape
> etc. One problem with this is that there is a bit of adhesive residue
> left that cause the brakes to grab for a while until it is burned off.
> I tried several solvents without total success for removing the
> adhesive. All is well now.
>
> John Teske
>
>
> **************
> Get trade secrets for amazing burgers. Watch "Cooking with Tyler
> Florence" on AOL Food.
> (http://food.aol.com/tyler-florence?video=4&?NCID=aolfod00030000000002)
>
> *************************************************************
>
> To unsubscribe or set your subscription options, please go to
> http://lists.psu.edu/cgi-bin/wa?SUBED1=l-forwardlook&A=1
> <http://lists.psu.edu/cgi-bin/wa?SUBED1=l-forwardlook&A=1>
>
> *************************************************************
>
> To unsubscribe or set your subscription options, please go to
> http://lists.psu.edu/cgi-bin/wa?SUBED1=l-forwardlook&A=1
> <http://lists.psu.edu/cgi-bin/wa?SUBED1=l-forwardlook&A=1>
>

*************************************************************

To unsubscribe or set your subscription options, please go to
http://lists.psu.edu/cgi-bin/wa?SUBED1=l-forwardlook&A=1

*************************************************************

To unsubscribe or set your subscription options, please go to
http://lists.psu.edu/cgi-bin/wa?SUBED1=l-forwardlook&A=1