|
Looking to adjust the valves on my 1956 277 poly
engine.
It's been years since I've adjusted valves on
anything and never on a mopar.
The book says .012 intake and .020 exhaust when the
engine is hot.
I just put the rockers on some new shafts. What
settings should I start at for a cold setting.
And anyone know the procedure.
When I did my last adjustment on a chevy engine. It
told me if intake on cyl 6 was closed, It told me which valves I could adjust at
the same time, so I didn't have to do them one at a time.
But I see no procedure in my shop manual for
this.
Can these be fine tuned adjutsed while it's
running? I've heard you back off the adjuster until it taps a bit and then 1/4
of a turn tighter and no need for a feeler guage.
Any suggestions or tricks for the cold or hot
setting.
Thanks,
Nick
*************************************************************
To unsubscribe or set your subscription options,
please go to
http://lists.psu.edu/cgi-bin/wa?SUBED1=l-forwardlook&A=1
| 
Back to the Home of the Forward Look Network