RE: [Chrysler300] 1957 crankshaft pulley A/C car

["John Mc Adams" <clafong@xxxxxxxxxxxxx>]

Rusty Roe:

 

I do not know if these people can help you or not with your early Hemi (392)
motor.  They advertise the pulleys for the later wedge engines and later
(426 - 532 Hemi's) and they seem to have most of them covered.
http://www.bouchillonperformance.com/BPEpulleys.asp

 

If the URL doesn't get through they are called Bouchillon Performance
Engineering you can E-Mail them at RB@xxxxxxxxxxxxxxxxxxxxxxxxx     They are
located in South Carolina.  (843) 744-6559  

 

(For all of the wedge engine members out there, they even have a replacement
idler pulley for the later B/RB wedge engines with A/C that will allow you
to replace the bearing later on if it should go bad.)

 

I have relayed this info a couple of times before to club members with early
Hemi pulley problems but did not hear if they were able to help or not.  If
they can help you, please let me know back for my information.

 

Good Luck,

 

Big John Mc Adams

(In SoCal)

 

 

  _____  

From: Chrysler300@xxxxxxxxxxxxxxx [mailto:Chrysler300@xxxxxxxxxxxxxxx] On
Behalf Of Russell Roe
Sent: Tuesday, August 26, 2008 12:27 AM
To: Chrysler300@xxxxxxxxxxxxxxx
Subject: [Chrysler300] 1957 crankshaft pulley A/C car

 


I need the crankshaft pulley or pulleys for a 1957 392 hemi motor for a 300C
with factory Air conditioning......mine looks to be 2 pulleys....each with 2
grooves....they fit together making a 4 groove pulley.....the inner 2
grooves closer to the engine block are smaller in diameter..approx 6
inches....the outer pulley is about 7 1/4 in diameter and has 2
grooves...the car has factory a/c....the pulley fell off after only being on
the motor for 51 years and naturally it was at 40mph and I ran over it and
ruined it.......it stands about 4 1/2 inches tall ..that would be the
measurement from the rear where it bolts to the harmonic balancer to the
front of the pulley near the radiator.......I hope this all makes sense and
also hope one of you has what I need and wants to part with
it..........thanks in advance Rusty Roe in Hermiston Oregon 1957 300c #
3N572550

[Non-text portions of this message have been removed]

 



[Non-text portions of this message have been removed]


------------------------------------

To send a message to this group, send an email to:
Chrysler300@xxxxxxxxxxxxxxx

For list server instructions, go to http://www.chrysler300club.com/yahoolist/inst.htm

For archives go to http://www.forwardlook.net/300-archive/Yahoo! Groups Links

<*> To visit your group on the web, go to:
    http://groups.yahoo.com/group/Chrysler300/

<*> Your email settings:
    Individual Email | Traditional

<*> To change settings online go to:
    http://groups.yahoo.com/group/Chrysler300/join
    (Yahoo! ID required)

<*> To change settings via email:
    mailto:Chrysler300-digest@xxxxxxxxxxxxxxx 
    mailto:Chrysler300-fullfeatured@xxxxxxxxxxxxxxx

<*> To unsubscribe from this group, send an email to:
    Chrysler300-unsubscribe@xxxxxxxxxxxxxxx

<*> Your use of Yahoo! Groups is subject to:
    http://docs.yahoo.com/info/terms/