Re: [Chrysler300] Tach needed for my K

["kmaniak@xxxxxxx [Chrysler300]" <Chrysler300-noreply@xxxxxxxxxxxxxxx>]

Hugh:

 

As added information, Chrysler used the same cable driven tachometer assembly for model years 1960 through 1964.  The tachometer was standard from the factory in all letter cars 1960 through 1963 and factory installed only in 1964 Chryslers with manual transmission AND console.  I am sure these tachometers were installed in other cars after the factory.  The gauge reads from 0 to 6000 rpm.  And, yes, it will bolt right up in your console.  Good luck with your search.

 

Chris the KMANIAC

 

 

-----Original Message-----
From: Hugh Baldus hugh@xxxxxxxxxxxxxxxxx [Chrysler300] <Chrysler300-noreply@xxxxxxxxxxxxxxx>
To: Chrysler300 <Chrysler300@xxxxxxxxxxxxxxx>
Sent: Wed, Jul 30, 2014 4:55 am
Subject: [Chrysler300] Tach needed for my K

 

Hi there,

 

I am looking to replace the vacuum gauge in my K with a tach, as my distributor is of the tach-drive persuasion.  Anyone out there have a lead on one?  Been down this road, and have advice?  Of course, I would retain the replaced gauge should a return to stock be desired in the future.  Thanks- 

 

Hugh Baldus

The Baldus Company

260.424.2366

 

__._,_.___

---

Posted by: kmaniak@xxxxxxx

---

To send a message to this group, send an email to:
Chrysler300@xxxxxxxxxxxxxxx

To unsubscribe from this group, send an email to bob@xxxxxxxxxxxxx or
go to http://autos.groups.yahoo.com/group/Chrysler300/join and select the "Leave Group" button

For list server instructions, go to http://www.chrysler300club.com/yahoolist/inst.htm

For archives go to http://www.forwardlook.net/300-archive/search.htm#querylang

Visit Your Group

• Privacy • Unsubscribe • Terms of Use

__,_._,___