Re: [Chrysler300] my '56 Imperial Power Steering is bleeding
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Chrysler300] my '56 Imperial Power Steering is bleeding





To ad to that, the upper reservoir is separate from the lower pressurized part. From your description, it is probably coming up from the lower part. I would try some Lucas power steering conditioner before I tried getting it sealed. It’s a very complicated box with lots of special tools required. I just swapped one in my 56, and plan to try taking the old one apart.
Don
 
Sent: Tuesday, September 19, 2017 11:33 PM
Subject: RE: [Chrysler300] my '56 Imperial Power Steering is bleeding
 
 

Hi Mark,
After looking at the picture shown below; the hole is a vent. Power steering fluid should not be coming out the hole.
Your seal is probably hard. Several years ago, I had the same problem on our 1957 300C for a short time. It did not leak on the floor. I attributed it to not driving our 300C enough for several years while I was recovering from my second heart surgery. If the leak continues, you may have to reseal the power steering unit.

The leak stopped after driving the 300C more often.

Good luck.

John

From: Chrysler300@xxxxxxxxxxxxxxx [mailto:Chrysler300@xxxxxxxxxxxxxxx] On Behalf Of mark love marklove@xxxxxx [Chrysler300]
Sent: Tuesday, September 19, 2017 8:55 PM
To: Chrysler300@xxxxxxxxxxxxxxx
Subject: [Chrysler300] my '56 Imperial Power Steering is bleeding


Hi all; just took delivery of a ’55 C73 Sedan. Started up and rode very well in the first shakedown only to get home and come back and see steering fluid on the ground. Looked down on the steering box and noticed a little hole and the fluid coming out quite quikcly. Checked the manual. The shop manual shows a ‘plug’ where the two halves of the power steering box join.
This one is gone
Can anyone advise on the plug? I shopped for the one specified in the manual, put it in but it appears to be too small (3/16” d).
Thanks, here are couple of pics
Mark.

.

[Non-text portions of this message have been removed]



__._,_.___

Posted by: <dverity@xxxxxxxxxxx>


To send a message to this group, send an email to:
Chrysler300@xxxxxxxxxxxxxxx

To unsubscribe from this group, send an email to bob@xxxxxxxxxxxxx or
go to https://groups.yahoo.com/neo/groups/all/manage/edit

For list server instructions, go to http://www.chrysler300club.com/yahoolist/inst.htm

For archives go to http://www.forwardlook.net/300-archive/search.htm#querylang





__,_._,___


Home Back to the Home of the Forward Look Network Archive Sitemap


Copyright © The Forward Look Network. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
This site contains affiliate links for which we may be compensated.