[Chrysler300] 62 Sport problem

["doug warrener 2HsandaHeritage@xxxxxxxxxxx [Chrysler300]" <Chrysler300-noreply@xxxxxxxxxxxxxxx>]

Hi Group,

I need some expert input on my 62 sport conv misfiring or "stumbling". The car has the standard 413 and I have added the dual AFB's and a dual point distributor.

One year ago driving to and from the Ironstone Concours in Murphys, CA ( about 80 miles away) I experienced severe  misfiring.

Pulled all the plugs and found #2, #6 & #7 fouled with carbon deposits ( #2 by far the worst).

Replaced the plugs and thought the problem was solved. This year, drove to local shows and around my neighborhood with no problems.

The trip to the Ironstone Concours this year resulted in the same misfiring  problem.

Pulled all the plugs and only #2 had any carbon deposits.

Checked the compression and all cylinders at 150 +/-.

Checked and set point gaps, replaced the wire to #2 plug.

The engine runs ok with no load, but still misfires or "stumbles under load and at high speed.

The new plugs that I installed last year are Autolite A42B's which I believe are correct. However they may be 30years old or older. The cap and rotor are only a year or two old.

Could a defective coil cause the problem?

Thanks,

Doug Warrener 

__._,_.___

---

Posted by: doug warrener <2hsandaheritage@xxxxxxxxxxx>

---

To send a message to this group, send an email to:
Chrysler300@xxxxxxxxxxxxxxx

To unsubscribe from this group, send an email to bob@xxxxxxxxxxxxx or
go to https://groups.yahoo.com/neo/groups/all/manage/edit

For list server instructions, go to http://www.chrysler300club.com/yahoolist/inst.htm

For archives go to http://www.forwardlook.net/300-archive/search.htm#querylang

Visit Your Group

• New Members 1

• Privacy • Unsubscribe • Terms of Use

__,_._,___