RE: [Chrysler300] 62 Sport problem
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

RE: [Chrysler300] 62 Sport problem





I once tried, unsuccessfully, to assist a fellow 300’er with intermittent misfiring 413 that eventually quit altogether.  Eventually, it was found to be a looseness at one of the tiny screws or hex nuts connecting the two point sets.  I understand that little wire can also fail—totally or partially.  Can be hard to diagnose..  Head-slapper when found.  Everything can fail—capacitors, wiring, coil, dropping resistor and any connection—including the bulkhead connector.  Fire must come from the ignition switch..

 

Rich Barber

Brentwood, CA-Endless summer here.

 

From: Chrysler300@xxxxxxxxxxxxxxx <Chrysler300@xxxxxxxxxxxxxxx> On Behalf Of doug warrener 2HsandaHeritage@xxxxxxxxxxx [Chrysler300]
Sent: Sunday, October 28, 2018 1:36 PM
To: Chrysler300 <Chrysler300@xxxxxxxxxxxxxxx>
Subject: [Chrysler300] 62 Sport problem

 

 

Hi Group,

I need some expert input on my 62 sport conv misfiring or "stumbling". The car has the standard 413 and I have added the dual AFB's and a dual point distributor.

One year ago driving to and from the Ironstone Concours in Murphys, CA ( about 80 miles away) I experienced severe  misfiring.

Pulled all the plugs and found #2, #6 & #7 fouled with carbon deposits ( #2 by far the worst).

Replaced the plugs and thought the problem was solved. This year, drove to local shows and around my neighborhood with no problems.

The trip to the Ironstone Concours this year resulted in the same misfiring  problem.

Pulled all the plugs and only #2 had any carbon deposits.

Checked the compression and all cylinders at 150 +/-.

Checked and set point gaps, replaced the wire to #2 plug.

The engine runs ok with no load, but still misfires or "stumbles under load and at high speed.

The new plugs that I installed last year are Autolite A42B's which I believe are correct. However they may be 30years old or older. The cap and rotor are only a year or two old.

Could a defective coil cause the problem?

Thanks,

Doug Warrener 

 

 

 

 



__._,_.___

Posted by: "Rich Barber" <c300@xxxxxxx>


To send a message to this group, send an email to:
Chrysler300@xxxxxxxxxxxxxxx

To unsubscribe from this group, send an email to bob@xxxxxxxxxxxxx or
go to https://groups.yahoo.com/neo/groups/all/manage/edit

For list server instructions, go to http://www.chrysler300club.com/yahoolist/inst.htm

For archives go to http://www.forwardlook.net/300-archive/search.htm#querylang





__,_._,___


Home Back to the Home of the Forward Look Network Archive Sitemap


Copyright © The Forward Look Network. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
This site contains affiliate links for which we may be compensated.