Re: [Chrysler300] 64 crank pulley question

["ALLAN POZDOL apozdol@xxxxxxxxxxx [Chrysler300]" <Chrysler300-noreply@xxxxxxxxxxxxxxx>]

Certainly true. The number I found indicates VC2 and Police, which is why I am asking. That big honker will add to mass, but would smooth thing out for torque. Like big flywheels in a Harley!

I just bead blasted the stamped pulley set up. No numbers!

On April 11, 2020 at 5:54 PM "paul paulholm@xxxxxxxxxxxxx [Chrysler300]" <Chrysler300-noreply@xxxxxxxxxxxxxxx> wrote:

 

On 4/11/2020 4:40 PM, ALLAN POZDOL apozdol@xxxxxxxxxxx [Chrysler300] wrote:
>
>
> Hey, I wanted to replace the four sheave crank pulley on my 300 K. This
> is because the one I pulled off appears to have gotten banged up in the
> past and poor attempts to straighten them. I had noticed my belts were
> shaking a bit and the PS pump was pretty jumpy as well.
>
> I found a NOS pulley, 2465725 as the '64 parts book indicated and
> received it today. It is cast iron with the 2465725 cast on it.
>
> Is the cast iron pulley correct for '64, or did someone put on a later
> albeit bent up stamped steel pulley? Dimensions are the same, but the
> weight difference is remarkable!
>
> Allan
>

well, that is rotating mass and the more there is the more energy it
takes to change its motion. SO - Lighter material revs faster!

--
Paul Holmgren
JCI #74145
"The secret of freedom lies in educating people, whereas
the secret of tyranny is in keeping them ignorant."
Maximilien Robespierre 1758-1794

 

__._,_.___

---

Posted by: ALLAN POZDOL <apozdol@xxxxxxxxxxx>

---

To send a message to this group, send an email to:
Chrysler300@xxxxxxxxxxxxxxx

To unsubscribe from this group, send an email to bob@xxxxxxxxxxxxx or
go to https://groups.yahoo.com/neo/groups/all/manage/edit

For list server instructions, go to http://www.chrysler300club.com/yahoolist/inst.htm

For archives go to http://www.forwardlook.net/300-archive/search.htm#querylang

Visit Your Group

• Privacy • Unsubscribe • Terms of Use

__,_._,___