Re: {Chrysler 300} Stainless rocker molding installation tips

Hi Kurt,

My H had sheet metal screws attaching clips to rocker and front quarters. No rubber pads and I'm pretty sure no sealant on the screws. I don't see any issues with putting sealant on screws if you want but I doubt it will make much difference. You might want to use stainless steel screws but original were not.

Good luck,

Joe

On Friday, August 12, 2022 at 01:43:13 PM EDT, kurt.brueske <kurt.brueske@xxxxxxxxx> wrote:

I recently sourced and restored a set of stainless rocker moldings with rear wheel "dog leg" stone guards for my 62 300H and was wondering if Club members might have any installation recommendations?

I have the correct clips (Quirey) but am wondering what type of screws I should use to secure them correctly. Do I need to place any material (e.g., rubber) between the clips and the body? Sealer to prevent water penetration? Etc., etc.

I don't believe my car originally came with the moldings and I am adding them based on personal taste. I'm a bit nervous about drilling holes in body panels and want to make sure I do things correctly!

Thanks in advance, have a great weekend.

Kurt

--
For archives go to http://www.forwardlook.net/300-archive/search.htm#querylang
---
You received this message because you are subscribed to the Google Groups "Chrysler 300 Club International" group.
To unsubscribe from this group and stop receiving emails from it, send an email to chrysler-300-club-international+unsubscribe@xxxxxxxxxxxxxxxx.
To view this discussion on the web visit https://groups.google.com/d/msgid/chrysler-300-club-international/5a69e74d-3d9c-4d92-a5f7-29b617c5c389n%40googlegroups.com.