Re: headers with a 440/4spd in a 63 B-body

[Bill <fshrmanbill@xxxxxxx>]

[AD removed for archives]
-------------------------------------------------------------------
Get a free* Bible and salvation reading plan.  Click here.
caac2N9a/PermissionData
-------------------------------------------------------------------


Doug, I own a 63' Fury factory 4 speed car. I have rebuilt the car completely 
from the ground up. I have a big block, 833 4 speed, and 63/65 bell housing 
and correct Z bar installed. I installed ceramic coated Headman Headers which I 
bought from Summit. These headers were supposed to fit, well, after a little 
hammering they did. This past summer at a car show, I ran onto another 63' 
with TTI's installed. Perfit fit all the way, so I replaced mine a couple months 
ago. Lots of clearance around the starter, Z bar, tie rods. Only way to go. 
Hope this helps, thanks Bill

[Non-text portions of this message have been removed]

[AD removed for archives]
-------------------------------------------------------------------
How about a cruise on your favorite cruise line-from us?  Click 
here.
caac2NYf/PermissionData
-------------------------------------------------------------------

----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html. 



http:///u/?.