RE: rod bearing holes

["Westerlund, Ken" <kwesterlund@xxxxxxxxxx>]

===========================================================
Let University of Phoenix make 2004 your year. Evening, 
weekend or FlexNet® classes ? over 130 locations. Look 
into our programs and get the degree that gets you going!
caab6aBb7yoMza/ UOP
===========================================================



Hi Don,
Thanks for the words of advice.  I like the Clevite 77 bearings, but I
figured if Ma Mopar used the oil squirt holes they had to be good.  :-)

Regards,
Ken

-----Original Message-----
From: Don Dulmage [mailto:big-d@xxxxxxxxxxxx] 
Sent: Tuesday, April 20, 2004 7:11 PM
To: 1962to1965mopars@xxxxxxxxxx
Subject: rod bearing holes


yes go ahead and use them. 
if you need guidance in the future just remeber this little rule nothing
and i do mean nothing, made by Clevite, TRW, Sealed Power or Federal
Mogul is bad. It may not be as exotic as smoe like but it is never bad.
They set the industry standard and have for many many years
Don

===========================================================
Sign up to get FREE information from leading colleges!
Compare degrees, admissions, financial aid and more.
Study your career education options at 
Collegeinformation.info. 
caab8K7b7yoMzf/ College Info
===========================================================


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html. 



b7yoMz.