Oil pick-up

[Joeydahook9@xxxxxxx]

[AD removed for archives]
-------------------------------------------------------------------
Save up to 67% on Omaha Steaks + Get 6 FREE Burgers and a 
FREE Cutlery Set + Cutting Board!
caacpgjb7yoMza/OmahaSteaks
-------------------------------------------------------------------


  Well, with a somewhat steady hand and a keen eye, I drilled out the 3/8" 
oil pick up and tapped it with a tapered 1/2" ips tap.  I only drilled down 
about an inch and a half and tapped it about 3/4".  Should I drill it down to the 
bit bottoms out?  I was going clean up the chamfer where I stopped drilling 
with the factory hole.  My main concern was cracking the boss where the pick up 
screws in.  Went pretty well.  A friend of mine assisted with cutting oil 
duties and he said he don't see what difference the upgrade makes.  I told him 
that if it was good enough for ma Mopar, it was good enough for me.   BTW - is 
locktight ok for the threads or should I put a small tack on it with the wire 
feed?   Joe

--
[Non-text portions of this message have been removed]

[AD removed for archives]
-------------------------------------------------------------------
Apply now for a No-Annual-Fee Discover® Platinum Card 
0% Intro APR*, No Annual Fee, Up to 2% Cashback Bonus® 
award* Start Saving Today ? APPLY NOW! It's fast, easy and 
secure.
caacpgwb7yoMzf/DiscoverCard
-------------------------------------------------------------------

----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html. 



b7yoMz.