Hood adjustment

[Tony Brummett <brummett@xxxxxxxxx>]

[AD removed for archives]
-------------------------------------------------------------------
Save up to 67% on Omaha Steaks + Get 6 FREE Burgers and a 
FREE Cutlery Set + Cutting Board!
caacvgpb7yoMza/OmahaSteaks
-------------------------------------------------------------------

I'm finally down to the details on my '64 Dodge.  Today's project was
getting the closed
hood to line up with the fenders.  The problem is the driver's side
rear most corner where
it meets the cowl.  It sticks up about a half inch.  I know the hood's
spring bracket has
slotted holes to adjust the height of that corner, but I have them
adjusted as low as it'll
go, and it still sticks up.  Adjusting the rubber stop at the front
corner didn't have any
effect either.

If I put my weight on the corner that sticks up, it'll go down most of
the way, but pops back
up when I let off.  Is there another adjustment I don't know about? 
Or maybe the hinge or
bracket is just worn out...

Thanks,
-- Tony  tony@xxxxxxxxxx
'64 Dodge 440
'64 Dart 'vert
'65 Dart GT

[AD removed for archives]
-------------------------------------------------------------------
Get a Great Credit Card for You Today 
You can find a credit card to fit your credit needs.  
All types of credit cards -- 0% APRs, Rewards, & Bad Credit.
caacvgub7yoMzf/411Web
-------------------------------------------------------------------

----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html. 



b7yoMz.