Re: Port mismatch with poly Weiand intake

[Joeydahook9@xxxxxxx]

[AD removed for archives]
-------------------------------------------------------------------
Get a Holy Bible for FREE!
caacYkCbOk33ra/PermissionData
-------------------------------------------------------------------


You can get a carbide porting bit from a NAPA store, they usually run  about 
20.00 and come in many shapes.  An oval shape is probably the best to  have if 
you only need one.  It will load up with aluminum if you don't put  grease on 
it.  Some use atf or even wd 40 on the bits.  They come in  different 
lengths, but about a 4" is all you need for gasket matching.  The  longer the bit, 
the more $$$.  The shafts are 1/4" in diameter, so your  Dremel will need a 1/4" 
collet.  I use a cheepo air die grinder  ($25).  Works slow, but works.  
Kinda like me ;o)    Joe

[Non-text portions of this message have been removed]

[AD removed for archives]
-------------------------------------------------------------------
Amazing Diet Patch
The fastest - Easiest way to lose weight! Try it now FREE!
caacYkHbOk33rf/MyDietPatches
-------------------------------------------------------------------

----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html. 



bOk33r.