Re: Subject: 63 wagon

[rll <rlipinski3@xxxxxxx>]

Subject: 63 wagon



Hadnt noticed before that a 63 Dodge wagon was called a Coronet! 

Sorely tempted by this one:
http://cgi.ebay.com/ebaymotors/1963-Coronet-440-Wagon-CUSTOM-FULL-RESTORATION_W0QQitemZ270095216169QQihZ017QQcategoryZ6200QQrdZ1QQcmdZViewItem

Hope the link works.

Anyone know the car? or the vendor?

It says it has a 9" rear end - can anyone out there tell from the pics whether 
that is a Ford 9"?


hello list


Others have mentioned they thought the rear is a 8 3/4 mopar

i agree...ford 9"s have a front pinion bearing the yoke goes into.

i couldn't see any numbers on the case but a housing swap to change from
the tapered axles could have been done.

as much detail as was done to that car one would thing you could
install the shifter knob right side up.

rob and ferts in phx 


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html.