RE: Git R Done

[Richard Kinsley <r.kinsley@xxxxxxxxxxxxxxxx>]

Robert (UK) wrote:
> 
> We were told our Polara had 3.91's in it when we bought it, and checked 
> it roughly soon after getting the car, and it sure looked like 3.91 
> judging by the number of turns the drive shaft does for the number of 
> times the wheels turn.
> Since then though, we think the ratio might be a litle (numerically) 
> lower than that, though not as low as 3.55.
> 
> Until now I thought the gear options for the 8-3/4 were 3.23, 3.55, 
> 3.91, 4.10 plus a few above and below.
> 
> Is there a 3.73 or similar? Maybe we (my brother, actually!) mis-counted 
> 
> the roughly 3.9 turns and it was nearer 3.7?
> 
> Thanks in advance
> 
> Robert
> 63 Polara 500
> England

=====================================================================

I was under the impression the 8&3/4's had 373's available. At least 
once upon a time.



Rich Kinsley  '64 Polara 4 dr 318poly w/goodies


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html.