Smokin' Poly

[Bill <Y1TopBanana73@xxxxxxxxx>]

Hey everyone, I'm back after a terrible week in Cancun. All that bright 
sun, all those those gorgeous bathing beauties, all those free drinks 
...almost more than a man can take!!! HAHAHA!!

Anyway...The REAL subject of this is my recently smokin' poly. Within 
the last couple of weeks I started noticing smoke when cruising and now 
on decel too...especially out of the drivers side. It's definitely oil 
smoke and it seems to have gotten a little worse since I changed from 
Mobil 1 to Rotella.

So I'm trying to figure out of I've got rings or valve guides going out 
or a blown head gasket? The motor just turned over 81,000 miles so I'm a 
little leary of just re-doing the top end for fear of blowing out the 
bottom end. Do you think I would be OK by just pulling the heads and 
replacing the head gaskets if necessary? Or should I probably plan on a 
full rebuild &/or build up??

Next question is...whose the best source for poly motor gaskets and 
rebuilt parts these days?

Thanks

Bill M
65 Coronet 500 'vert


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html.