Re: another radiator hose question

[george smith <bt6t4@xxxxxxxxx>]

neither of my molded hoses have the spring.I think if
you have the correct rad. cap an event like that
shouldn't occur. 
--- Lee Sumpter <leesumpter@xxxxxxxxx> wrote:

> I found a molded hose to fit the lower side of my 64
> Plymouth 361.
> However after I installed it, I realized that it did
> not have the
> spring inside. The FSM says that the spring is
> necessary to prevent
> the hose from sucking shut at high speeds/rpms.
> Anyone on the list
> have any experience with this? Am I going to have
> problems with this,
> or should I find another hose with the spring?
> Thanks for your opinions.........
> 
> 
> -- 
> Lee Sumpter
> 


George



      ____________________________________________________________________________________
Never miss a thing.  Make Yahoo your home page. 
http://www.yahoo.com/r/hs


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html.