RE: exhaust manifolds

[george smith <bt6t4@xxxxxxxxx>]

I put the red silicone on and put the manifolds on
immediately.The engine sat for a couple mos. before I
fired it up.No leaks at all..so far.I don't expect
any.
--- Sean B <polecat2@xxxxxxxx> wrote:

> 
> George,
> 
> I was thinking of using the hi-temp copper Permatex
> stuff for my 
> exhaust.  Do you think the red stuff is better? 
> Further, did you allow 
> it to dry, or put them on wet?
> 
> Sean
> 
> 
> george smith wrote:
> > 
> > All I had to do w/ my MW manifolds was use a bead
> of red hi temp 
> > silicone around the ports for a gasket.No probs at
> all.
> 
> 
> ----
> Please address private mail -- mail of interest to
> only one person -- directly to that person.  I.e.,
> send parts/car transactions and negotiations as well
> as other personal messages only to the intended
> recipient, not to the Clubhouse public address. This
> practice will protect your privacy, reduce the total
> volume of mail and fine tune the content signal to
> Mopar topic.  Thanks!
> 
> '62 to '65 Mopar Clubhouse Discussion Guidelines:
> http://www.1962to1965mopar.ornocar.org/mletiq.html. 
>
> 
> 


George



      ____________________________________________________________________________________
Be a better friend, newshound, and 
know-it-all with Yahoo! Mobile.  Try it now.  http://mobile.yahoo.com/;_ylt=Ahu06i62sR8HDtDypao8Wcj9tAcJ


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html.