RE: Pinion snubber

[Rich Kinsley <rlkinsley@xxxxxxxxx>]

Joey Lemire wrote:
> 
> 1 1/2" from floorboard seemed to work well for my street strip Dodge.
> 
> Joey
> ----- Original Message -----
> From: "Rich Kinsley" <rlkinsley@xxxxxxxxx>
> To: <1962to1965mopars@xxxxxxxxxx>
> Sent: Thursday, June 05, 2008 8:50 PM
> Subject: Pinion snubber
> 
> 
> >
> >
> >
> > Rich Kinsley '64 Dodge Polara 4dr 318poly w/goodies
> >
> > I remember once someone mentioning the proper postion for a pinion
> > snubber. About how far from the floorboard should it be? Mine was about
> > 1" plus so I put it one notch up and just noticed that it actually
> > touches the floor board. Whoops. No wonder it started riding so hard :-)
> > What should it be ?
=====================================================================

I reset mine last night. It is the Mopar one with holes in it and a pin 
to change adjustment so you don't really get a lot of choice. Maybe I 
could just drill a new hole where I wanted it. It's probably a little 
more than 1&1/2" but it's OK I guess. I have some pretty stiff springs 
now and I doubt if my engine could wrap-em up.


Rich Kinsley '64 Dodge Polara 4dr 318poly w/goodies


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html.