Re: another, more, scattershield questions

[chymar01@xxxxxxxxxxx]

You can also buy a replacement plate from Lakewood. I think Summit sells them for about $80. The starter mount kit is $30 if I remember correctly. I bought one about two years ago.

Mark

-------------- Original message -------------- 
From: Dave Casey <dcasey@xxxxxxxxxxxxx> 

> 
> The Lakewood scattershields did have a plate, and yes, it was 1/4" steel. 
> You can probably find one pretty cheap if someone has it but not the 
> bellhousings. Also, do you have the little piece that holds the nose of the 
> starter? You'll want to find that if you don't... 
> 
> Dave Casey 
> 
> ----- Original Message ----- 
> From: "neal zimmerman" 
> To: <1962to1965mopars@xxxxxxxxxx> 
> Sent: Monday, October 13, 2008 8:47 PM 
> Subject: another, more, scattershield questions 
> 
> 
> >i have another question about scattershields. 
> > The only real reason i bought it was that I couldnt find a 
> > reasonably priced OEM big block bellhousing, and I got it for 100 
> > dollars , as opposed to the 350 dollars I see the OEM pieces going 
> > for, so I figured theres 250 bucks towards something else. 
> > Now I have seen them in catalogs with and without the inner plate 
> > that goes between the back of engine and clutch, to protect back of 
> > block in event of explosion. 
> > Mine had no inner plate. whether it did originally or not we will 
> > never know. 
> > is it OK to run it without the inner plate? I mean we are mainly 
> > talking a street car, not a full on drag strip car so will it still 
> > function correctly?? The only problem I can see is if it was meant to 
> > be run with the inner plate it would affect ( by about 1/4 inch) how 
> > far the input shaft of tranny went into back of crank, but i cant seee 
> > how that would be an isssue and also there might be an issue with the 
> > starter depth. 
> > Now , on the other hand if i decided to make one, (easy enough i 
> > think with my plasma cutter and a template), could it just be made on 
> > a sheet of 1/4 inch steel, or would i need to have the plate milled 
> > flat after i cut it out. I dont know how really " flat" a sheet of 
> > steel actually is. 
> > thanks guys 
> > neal zimmerman, eugene oregon 
> > 
> 
> 
> ---- 
> Please address private mail -- mail of interest to only one person -- directly 
> to that person. I.e., send parts/car transactions and negotiations as well as 
> other personal messages only to the intended recipient, not to the Clubhouse 
> public address. This practice will protect your privacy, reduce the total volume 
> of mail and fine tune the content signal to Mopar topic. Thanks! 
> 
> '62 to '65 Mopar Clubhouse Discussion Guidelines: 
> http://www.1962to1965mopar.ornocar.org/mletiq.html. 
> 
> 
--
[Non-text portions of this message have been removed]


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html.