cam timing

[William Harrison <bbjt3@xxxxxxxxx>]

Here is a new topic for you Mopar heads.
I recently started installing a stroker kit in my 383 and am using a solid roller set up.
I used a degree wheel to find true tdc and it is 2 degrees retarded.
My crank gear has the ability to be advanced or retarded 2 or 4 degrees.
Which is the best setting for a roller set up.
This motor will not see the street; it will get used a quarter mile at a time.
Any suggestions appreciated.
Thanks
Bill Harrison
65 Coronet 2 dr post.


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.