This link is a great help for easy strut rod bushing replacement project. I did this on my 64 440 and it was slick. I used a 6' pry bar I had laying around which was a great tool for this job! Ruth
On Wed, Oct 12, 2011 at 4:07 PM, Eric R
<hoodoovoodooray@xxxxxxxxx> wrote:
I'm looking at some pretty worn out steering and suspension pieces on
my '62 Newport. I'm going to replace the balls joints, tie rod ends
and upper strut bushings.
How do I check the centerlink? They seem pretty expensive, over
$300. Are there bushings for the idler arm and pittman arm?
Anything else that I should look at?
Many thanks in advance.
--
--
Please address private mail -- mail of interest to only one person -- directly to that person. That is, send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic. Thanks!
1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
--
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.
Back to the Home of the Forward Look Network