Re: Ball Joint Seperator Tool

[Bill M <y1topbanana73@xxxxxxxxx>]

I have the Harbor Freight version of this and it works well. Just don't OVER tighten it or you'll break it in half. Crank it down pretty good, then just step back and wait. If it doesn't pop after a few minutes (and it will scare teh crap out of you when it does) just heat the spindle a little...it will go, and it beats (pun intended) beating the crap out of your ball joint or spindle.

Bill M
65 Coronet 500 'vert http://1962to1965mopar.ornocar.com/mmo62008.html
73 Dart Sport, 00 Cherokee Sport, 05 Ram 2500 CTD, 4WD, QC, LB, Laramie

21 Model T Depot Hack, 92 Accord, 06 Mazda 3

On Fri, Oct 14, 2011 at 11:57 PM, Eric R <hoodoovoodooray@xxxxxxxxx> wrote:

Found this interesting tool online today while trying to pound my
balljoint away from my spindle.  Thought maybe someone here might find
it interesting as well.

http://www.amazon.com/OTC-6297-Ball-Joint-Separator/product-reviews/B0015PN010/ref=cm_cr_dp_all_helpful?ie=UTF8&showViewpoints=1&sortBy=bySubmissionDateDescending

-- 
--
Please address private mail -- mail of interest to only one person -- directly to that person. That is, send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!
 
1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
-- 
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.