|
Hi fellas, Just a couple of my experiences with mini-starters. I bought a new unit from Mancini's to crank my 493 motor but it wore out quickly. Looked like a Chinese copy of the Denso starter. To replace that unit I purchased a MSD starter but, it looks just like the one I wore out except for the shiny red paint job. So far it does the job. I also have a insulating sleeve over the starter to protect it from the header heat. Mike LeFevre On 10/15/2011 4:55 PM, Richard Kinsley wrote: You can use most any Mopar mini-starter in your car. In the link for the pro-something starter it lists the applications and the poly will be the same as the LA small blocks. Dakota starters seem to be the preferred choice. Perhaps easiest and cheapest to get. I have a Summit unit on mine since '06 and it works great. I would recommend using a heat shield blanket if it is close to the headers like my TTI's. That much heat can't be good for them. -- -- Please address private mail -- mail of interest to only one person -- directly to that person. That is, send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic. Thanks! 1962 to 1965 Mopar Clubhouse Discussion Guidelines: http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html. -- You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group. http://groups.google.com/group/1962to1965mopars?hl=en. |
Back to the Home of the Forward Look Network