Re: New member - ex 64 Chrysler

[Robert Gideon <rjgideon@xxxxxxxxx>]

On Wednesday, November 7, 2012 9:25:55 PM UTC-6, Roger Pettigrew wrote:

Ok,,,,, am guessing your going after a 62-64 tranny (flange type) seeing as you asked for a driveshaft as well, what are  you going to use for a shifter?  would be cool to see a dash shift lever from a van or pickup

 

In a message dated 11/7/2012 8:19:43 P.M. Central Standard Time, rjgi...@xxxxxxxxx writes:

 

I don't have any problem with the ball & trunion, so that's fine with me (flange type).  If I can't get a driveshaft with a flange type transmission, I can have one made, that's not a big deal, just a little costly.

 

I bought a Valiant shifter, I think it's a '64 unit with the round buttons.  My plan is to mount that horizontally at the bottom of the dash in the middle.  I thought it might be cool to sink it in between the seats, but these shifters are pretty bulky, so it would hang beneath the car.

 

 

-- 
-- 
--
Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks!
 
1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
-- 
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.