Re: 65 Coronet 727 Trans Shift Shaft Seal

["Bob H" <tgrrr@xxxxxxxxxxxxx>]

NAPA  #727-2112.....O-Ring seal trans cable

 

----- Original Message -----

From: Timothy Arnold

To: 1962to1965mopars@xxxxxxxxxxxxxxxx

Sent: Friday, December 14, 2012 9:40 PM

Subject: Re: 65 Coronet 727 Trans Shift Shaft Seal

Finally got the seal today & the one I was advised was the right seal by the parts guy was a Timken 8609.  Well it is not the correct seal it's about 3 times to large.  I cleaned & took the kick down rod off the shaft, it appears to be a small O ring type seal in the top.  I found http://www.nationalmoparts.com/merchant.ihtml?pid=4521&step=4 not sure if this is the correct one? 

If that is the correct one can I still do it without dropping the pan? 

Here is a link to picture the leak is coming from the Throttle Shaft that is on the picture.  http://s8.beta.photobucket.com/user/tnaz71/media/2012-12-14212809_zps1f333852.jpg.html

Thanks!

I will try and get a picture of the one on mine tomorrow 

--
--
--
Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks!
 
1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.
--
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en.