You can send a sample to Restoration Specialties and they will try to match. I did that with the roof edge clips on my 63 SF. But they were not able to match.--
Paul L.
On Tuesday, April 3, 2018 at 10:18:56 AM UTC-5, ricky.l.hall wrote:Managed to pop off the stainless trim with some plastic trim tools - to get it out of the way for lower rust repair - and have a straightening/polishing guru go over the un-optainium trim piece.
Believe it or not - Joe Suchy says he has no clips that look like these - nor any ’62 clips at all.
Anyone have a source? (pic attached)
From the lower rear qtr trim on my wagon. Fits in 5/16" holes in the qtr - measures .60 wide x 1.12 long.
Think the install will work better with fresh clips!
Ric
--
--
Please address private email -- email of interest to only one person -- directly to that person. That is, email your parts/car transactions and negotiations, as well as other personal messages, only to the intended recipient. Do not just press "reply" and send your email to everyone using the general '62-'65 Clubhouse public email address. This practice will protect your privacy, reduce the total volume of mail and fine-tune the content signal to Mopar topic. Thanks!
1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_ .disclaimer.html
--
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
http://groups.google.com/group/1962to1965mopars?hl=en .
---
You received this message because you are subscribed to the Google Groups "The 1962 to 1965 Mopar Mail List Clubhouse" group.
To unsubscribe from this group and stop receiving emails from it, send an email to 1962to1965mopars+unsubscribe@googlegroups.com .
For more options, visit https://groups.google.com/d/optout .
Back to the Home of the Forward Look Network