Re: IML: 1981 Imperial EFI starting problems. New member here.
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: IML: 1981 Imperial EFI starting problems. New member here.



Lee---It could be an ignition problem----Check for fire to plugs---If you have fire,loosen air cleaner nut and pour 2-3 oz of fuel into center recess and let it run down ---tighten nut and try starting----If it starts your problem could be the fuel pressure switch or in-tank pump pressure is low----check F S M for how to procede----car will NOT run without air cleaner on and tight------Mike Popp----82 FS Imperial with EFI
----- Original Message -----
From: lee hat jr
Sent: Sunday, October 23, 2005 5:08 PM
Subject: IML: 1981 Imperial EFI starting problems. New member here.

 
 I added an extra ground wire to the module
on the passenger fender,looks kind of like an Ignition module.
 
Is that the Module people talk about?There is a relay next to it also.
 
  I got the car to start today,let it run one minute,shut it off;
then tried to restart it,it wouldn't start.
 Unhooked all the relays,one at a time,and replugged them in to make sure all
connections were tight.Let it sit for 20 mins,and it started up,ran good.
 
 I let the car run about 10 mins,till the thermostat had opened,and made sure the engine was warm.
 I turned the car around in the driveway,turned it off,tried to restart it,and no luck.
 :(
 I can hear the intank fuel pump running.
 
Lee/cavemanmoron


Yahoo! FareChase - Search multiple travel sites in one click.


Home Back to the Home of the Forward Look Network


Copyright © The Forward Look Network. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
This site contains affiliate links for which we may be compensated.