Re: IML: Remove stainless roof panels from 60 LaBaron

[Kenyon Wills <imperialist1960@xxxxxxxxx>]

They will come out without heat or tools.  Mine get
fingers under the edge on the edge facing the center
of the roof and were pried upwards and they just came
out.

Be careful with the drip-rail stainless.  I am unable
to get mine off and the rail has a wave in it that I
doubt that I'll ever get out to my satisfaction.


There was a lot of rust under the stainless panels. 
There could be junk under there that is preventing
removal?

-Kenyon

--- Tom & Kellie Willson <tkwillson@xxxxxxxxxxxxxx>
wrote:

>  I am trying to remove the stainless roof panels.
> I have removed all trim around the panel except for
> the chrome drip 
> molding over the doors. The stainless panel appears
> to have a lip hooked 
> under the drip molding.
> I can not move either the drip molding or the
> stainless panel.
> Are they held in place with a sealant?  Would heat
> be helpful?
> What would you suggest?
> Tom
> 
> 
> 
> 
> -----------------  http://www.imperialclub.com 
> -----------------
> This message was sent to you by the Imperial Mailing
> List. Please 
> reply to mailing-list@xxxxxxxxxxxxxxxx and your
> response will be 
> shared with everyone. Private messages (and
> attachments) for the
> Administrators should be sent to
> webmaster@xxxxxxxxxxxxxxxx
> To UN-SUBSCRIBE, go to
> http://imperialclub.com/unsubscribe.htm
> 
> 


Kenyon Wills
 
 






















-----------------  http://www.imperialclub.com  -----------------
This message was sent to you by the Imperial Mailing List. Please 
reply to mailing-list@xxxxxxxxxxxxxxxx and your response will be 
shared with everyone. Private messages (and attachments) for the
Administrators should be sent to webmaster@xxxxxxxxxxxxxxxx
To UN-SUBSCRIBE, go to http://imperialclub.com/unsubscribe.htm