Re: IML: 1960 fuel pump

["Frederick Joslin" <fljoslin@xxxxxxxx>]

Make sure that the fuel pump actuator rod is pushed all the way in against the cam shaft. If the arm on the fuel pump is hitting the side of the actuator rod you will never get the pump on. This subject was written about in the not too distant past. Someone said to use grease to hould the rod in.
Good luck.

 

----- Original Message -----
From: "Donn Reese"
To: "Imperial mailing list \(E-mail\)"
Subject: IML: 1960 fuel pump
Date: Fri, 19 May 2006 00:09:22 -0800


I'm installing a new fuel pump from NAPA, their
part number M3672. Does anyone know if this is
the correct one for a 1960? Am having trouble
getting it installed, lining up the bolts has
been a headache. Or perhaps I need to turn the
engine a bit?

Thanks,

Donn Reese
1960 Imperial Custom 4dr Hardtop


----------------- http://www.imperialclub.com -----------------
This message was sent to you by the Imperial Mailing List. Please
reply to mailing-list@xxxxxxxxxxxxxxxx and your response will be
shared with everyone. Private messages (and attachments) for the
Administrators should be sent to webmaster@xxxxxxxxxxxxxxxx
To UN-SUBSCRIBE, go to http://imperialclub.com/unsubscribe.htm

Fred Joslin