Hola Tom
At the dash end, there is an large washer/nut holding it to the
dash. It is that "ring" around the mirror adjusting knob. It is
possible to use an large bladed flat screw-driver and tap it gently until it
is free.
At the fender mirror end us an long shank # 2 phillips head screw-driver
to take off the mirror from the fender.
At the inner fender/firewall area is an flexiable seal the mirror cable
goes through. If you pull/wiggle the assembly towards the front fender,
it seems to come off/out. The dash end of the cable is larger than the
little bitty hole of the seal, sooo the seal comes out too.
To re-assemble I use a piece of wire and go from the inside to the
outside. When the wire is sticking out the fender, the direction is
reversed to pull the unit back to the dash. The hardest part to me is
getting the seal fully back on.
And that is how I do it.
Rodger & Gabby
COS
----- Original Message -----
Sent: Wednesday, April 04, 2007 8:43
PM
Subject: IML: replaceing 66 imp
mirror
hi i have a 66 imperial and do not know how to replace
the
drivers side mirror, can any one till me how to
get the remote mirror
switch out off the dash?,thanks
tom
____________________________________________________________________________________
Sucker-punch
spam with award-winning protection.
Try the free Yahoo! Mail Beta.
http://advision.webevents.yahoo.com/mailbeta/features_spam.html
-----------------
http://www.imperialclub.com
-----------------
This message was sent to you by the Imperial Mailing
List. Please
reply to mailing-list@xxxxxxxxxxxxxxxx
and your response will be
shared with everyone. Private messages (and
attachments) for the
Administrators should be sent to webmaster@xxxxxxxxxxxxxxxx
To
UN-SUBSCRIBE, go to http://imperialclub.com/unsubscribe.htm
Back to the Home of the Forward Look Network