speed nuts

["jsadowski" <jsadowski@xxxxxxx>]

I used Moortite on these. Its like a putty that stays somewhat flexable. Its much like what was originally used. You can get black at auto paint stores. They sell a light gray kind at places like the Home Depot.

John

----- Original Message -----

From: roger crabtree

To: mailing-list@xxxxxxxxxxxxxxxx

Sent: Thursday, December 04, 2003 6:54 PM

Subject: Re: IML: speed nuts

Beware! silicon and paint do not mix.
RC Billings, Montanaaaaa

 --- Phil Patterson <hilljack7@xxxxxxxxxxxxx> wrote: >
I expect that its RTV silicon, or in older models,
> probably the old white potting sealant they used to
> use. I'd use RTV silicon, it should seal while not
> being too strong to prevent removal later.
> Phil <><
>   ----- Original Message -----
>   From: Bob
>   To: mailing-list@xxxxxxxxxxxxxxxx
>   Sent: Thursday, December 04, 2003 2:42 AM
>   Subject: IML: speed nuts
>
>
>   Does anyone know the correct sealant used in the
> hollow of speed nuts that hold on trim pieces?  I
> don't want to use anything with too much adhesive as
> the tangs on pot metal pieces are easy enough to
> break off as it is, but need to seal this source of
> water and moisture mitigation.  Years applicable are
> early 60's (1962), and there may have been more than
> one sealant used.  Thanks!!
>
>   Bob
> 

http://personals.yahoo.com.au - Yahoo! Personals
New people, new possibilities. FREE for a limited time.


-----------------  http://www.imperialclub.com  -----------------
This message was sent to you by the Imperial Mailing List. Please
reply to mailing-list@xxxxxxxxxxxxxxxx and your response will be
shared with everyone. Private messages (and attachments) for the
Administrators should be sent to webmaster@xxxxxxxxxxxxxxxx
To UN-SUBSCRIBE, go to http://imperialclub.com/unsubscribe.htm