That better be one hell of a solvent if it goes through the metal and into
the wood. I don't want to separate the wood from its backing. I'm talking
about dissolving the glue that holds the metal plate to the dash. In
addition, if I can make large enough holes behind the plate then maybe I
can push it out rather than prying around the edges from the front.
-- David
Christopher Hoffman
<imperial67@xxxxxxxxxxxx To:
<mailing-list@xxxxxxxxxxxxxxxx>
t> cc:
Sent by: Subject: Re: IML: '66
Coupe interior wood removal -- attack from the rear?
mailing-list-owner@imper
ialclub.com
09/09/2004 10:05 PM
Please respond to
mailing-list
Any solvent might soak past the glue into the wood and damage it. I'd try
heat before chemicals... Just my $0.02...
Chris in LA
67 Crown
78 NYB Salon
On 9/9/04 9:43 pm, David Whitney (david.whitney@xxxxxxxxxxxx) wrote:
> So what solvent is the right one for this glue?
----------------- http://www.imperialclub.com -----------------
This message was sent to you by the Imperial Mailing List. Please
reply to mailing-list@xxxxxxxxxxxxxxxx and your response will be
shared with everyone. Private messages (and attachments) for the
Administrators should be sent to webmaster@xxxxxxxxxxxxxxxx
To UN-SUBSCRIBE, go to http://imperialclub.com/unsubscribe.htm
----------------- http://www.imperialclub.com -----------------
This message was sent to you by the Imperial Mailing List. Please
reply to mailing-list@xxxxxxxxxxxxxxxx and your response will be
shared with everyone. Private messages (and attachments) for the
Administrators should be sent to webmaster@xxxxxxxxxxxxxxxx
To UN-SUBSCRIBE, go to http://imperialclub.com/unsubscribe.htm
Back to the Home of the Forward Look Network