Re: {Chrysler 300} Floor surfaces

I had my shop built in 2018 and had epoxy floor done after the building was done. They had to do a lot to the concrete to prep it as I had a lot of rust stains due to unexpected delay between the slab being done and the building going up.

I went with grey with full coverage flake in grey, black and white. The full coverage flake gives it more texture to give some grip. I don't have to worry about salt but nothing sticks to it so far. It will remove the paint from the bottom of cabinets, tool boxes, or anything else you slide over it.

I haven't had any problems with fading or yellowing, even on the door aprons that are always exposed.

On Mon, Apr 28, 2025, 10:01 AM Tom Wilburn <tomwilburn1@xxxxxxxxx> wrote:

I think this topic is consistent with list serve policy. Am refinishing the garage where I store my 300. Wondering about experience with concrete polishing vs epoxy etc.

I live in New England and worry about surfaces exposed to salt in winter. The back half of my garage will be for my 300 (not used in winter) and the front half for daily driver. Would like both to look great.

Any recommendations?

Tom
Sent from my iPhone

--
For archives go to http://www.forwardlook.net/300-archive/search.htm#querylang
---
You received this message because you are subscribed to the Google Groups "Chrysler 300 Club International" group.
To unsubscribe from this group and stop receiving emails from it, send an email to chrysler-300-club-international+unsubscribe@xxxxxxxxxxxxxxxx.
To view this discussion visit https://groups.google.com/d/msgid/chrysler-300-club-international/DD022D5B-7235-4E10-8370-4322A12E6678%40gmail.com.