Re: Won’t Start using Key
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: Won’t Start using Key




Hi Don,
Make sure the wire coming up to the starter relay from the neutral safety switch is grounded when the car is in park or neutral. If you disconnect the neutral safety switch, the car definitely won't start as this terminal has to see a ground before it will activate the relay. When you turn your switch to start, you should also have battery voltage to the terminal right below the main battery stud on the relay. By jumping to two top posts on the relay and making the car start, indicates that the wiring is all OK to the starter. The ballast resistor has nothing to do with the starter engaging.
Stevan Miner
Miner Auto Service
Winnebago, MN
----- Original Message ----- From: "Don" <dgallimore@xxxxxxxxxx>
To: "Mailing List" <1962to1965mopars@xxxxxxxxxx>
Sent: Sunday, June 03, 2007 8:51 AM
Subject: Won’t Start using Key



I’m assembling a “delivered in boxes” ’65 Satellite. I can’t get the starter to work through the ignition switch but can by jumping the post on the starter relay.

Things I’ve checked.
1. Power from the battery is getting to the ignition switch

2. There is conductivity through the ignition switch with the key on (IGN 1) and the key in the start position (IGN 2)

3. There is conductivity in the wires from the ignition switch to the bulkhead connector for both ignition circuits – tested in the engine compartment side.

3. The fuseable link from the starter relay to the Bulkhead has continuity.

4. I’ve replaced the new starter relay with another new starter relay with no success.

5. The ballast resister has the same resistance as that on my running ’65 Belvedere and the spare I always carry.

6. There is conductivity from the starter relay to the ballast resister.

7. If it matters, the fuel gauge, alternator gauge and instrument cluster lights all work. However, the oil pressure light did not glow.

8. Since it’s an automatic and to eliminate this as a possibility, I disconnected the neutral start wire from the starter relay. Before I did that, I held the key on and ran the shifter through the gears with no luck.

9. BTW – when we left the key in the ON position, the ballast resistor and coil were very hot.

So what’s the problem? I have a working car to swap working stuff off if that helps. Thanks.



           Akron Don
           ’65 Satellite 383/auto
           ’65 Belvedere 440/auto (manual shift)


----
Please address private mail -- mail of interest to only one person -- directly to that person. I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic. Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:





----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html.
This email was sent to: arc.6265@xxxxxxxxxxxxxx

u/?bUrDWg.bSONJP.YXJjLjYy



?p=TEXFOOTER






Home Back to the Home of the Forward Look Network


Copyright © The Forward Look Network. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
This site contains affiliate links for which we may be compensated.