Re: Door Alignment

[sky62 <sky62@xxxxxxxxxxxxx>]

Butch, My Service Tech Manual says to-

1. With the door in the open position, place a jack, with a block of  
wood
or pad on the lifting plate of the jack, as near the hinge as possible
(this will hold the weight of the door as the hinge bolts are loosened).

2. scribe a line around the hinge plates on the "A" post and also  
door panel.
Then remove the hinge attaching screws from the "A" post and remove the
door for further disassembly.

Install the door the same way with the hinges attached to the door  
panel,
jack underneath, then locate the hinge plates on the body "A" post  
and install
screws finger tight.

then adjust the jack to help align the hinge plates with the scribe  
marks and tighten
the attaching screws.

then complete the aligning procedure from there. adjusting the door  
striker etc...

hope this helps.
Schuyler
Schuyler 62 Dodge Dart 440 wagon w/ Poly 318
 <http://www.1962to1965mopar.ornocar.org/ml-wrobel62.html>
FYI - I Do the Decal designs for the Poly head 318 and more! email me  
with your needs -
 <sky62@xxxxxxxxxxxxx>



On Oct 15, 2007, at 10:49 AM, Butch Edison wrote:

> I sent my door hinges out to be refurbished. When I get them back,  
> I'll
> need to install them and adjust the doors for looks and ease of  
> use. It
> looks to me like the best way to reinstall the hinges is to put  
> them on
> the car first, then the doors. Sound right? I figure on loosening the
> door latching mechanism on the car, get the door looking right in the
> hole, then start tightening the hinge and door hardware, testing as I
> go.
>
> While this all sounds reasonable to me, I've never done this  
> before, so
> would appreciate any advice I can get from those of you who have.
>
> Thanks/Butch/ Ferndale, WA
>
> Mopar...if you have to ask, you'll never understand.


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html.