Re: Cam Swap Stuff-Bolts & Clearances

[William Cole <wedge64@xxxxxxxxxxx>]

Also Bill you can get aftemarker bolt sets from Summit, Jegs etc. if
you're worried about using old bolts.

Bill C.
On Fri, 24 Oct 2008 12:58:03 -0400, "Bill" <Y1TopBanana73@xxxxxxxxx>
said:
> I'm FINALLY going to do my cam swap soon and I'm thinking...will I be
> OK using the 43 year old intake bolts that are in the engine? or
> should I investigate getting new hardware? If so, who has them?
> 
> Also, this is my first solid lifter cam swap. When I set my cold
> valvetrain clearances, where should I do it...where the lifter meets
> the cam? If not then how am I going to set a clearance on a cupped
> pushrod mating to a rocker arm tip that fits in the cup? And then how
> should I do the hot clearance?
> 
> Thanks
> 
> Bill M
> 65 Coronet 500 'vert
-- 
  William Cole
  wedge64@xxxxxxxxxxx

-- 
http://www.fastmail.fm - I mean, what is it about a decent email service?


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html.