Winter project thoughts

[Rich Kinsley <rlkinsley@xxxxxxxxx>]

Rich Kinsley '64 Dodge Polara 4dr 318poly w/goodies

I remember someone mentioning that they built up the intake manifold 
under the carb venturi with JB Weld that tapered off towards the outside 
to help force the gases towards the intake valves. My Weiand WPD4D has a 
seperating wall between each side with only small notches as a balancer 
right under the carbs. I have been thinking of removing most of the wall 
under the carbs and perhaps building a small sheetmetal ramp over the 
center wall area. Perhaps I could drill and tap for screws to fasten it 
down. I'd kinda like to get the manifold powdercoated so while it's out 
I could play with it a bit. Maybe JB Weld would be a better option but 
I'm wondering what would happen if it broke up and headed into the 
engine?  Anybody got any thoughts of what impact this mod might have?


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html.