RE: Rear Glass 64 Polara 2dr hdtp

["Gary H." <62to65mopar@xxxxxxxxxxx>]

The main reason to remove the glass is to check for rust - rot out under 
the bottom, especially near the edges.

There are about 10 glass vendors listed on the 62-65 Vendor's Page you 
can check with. 

A good glass tech (one who has patience!) should be able to remove the 
glass without issue. It's pretty easy to get out if you don't care to 
reuse the gasket, as you cut the old gasket off. Just never touch the 
glass itself with a metal knife or screwdriver! I think repro gaskets 
are available. Check the vendors like Kramer and Suchy. You'll probably 
need new trim clips too. Line up all the parts before the glass is 
messed with. 

Thanks,
Gary H.


blosserde@  wrote:
> 
> Does anyone have a source for the rear glass for my Dodge?
> 
> Can the rear glass come out easy or do they tend to break?
> 
> I have heard both, but would like to remove both front and rear glass 
> before painting
> 
> I have tried some salvage yard. Front is available but can't find rear. 
> 
> Should glass guy be able to get it out? Or would you not take a chance 
> unless you has a replacement?
> 
> Thanks
> David 


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

1962 to 1965 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html and http://www.1962to1965mopar.ornocar.com/general_disclaimer.html.