Clearance

[roger crabtree <rcrabshish@xxxxxxxxxxxx>]

Man I have a 55 imp stocker and I drag all over town. 
My ford I used laker pipes to take the abuse.  When
done take off and throw away.Works for that but it is
the bumpers on the imp.  Try Lakers, they look good
to. RC



 --- Kenyon Wills <imperialist1960@xxxxxxxxx> wrote: >
Your local 4WD parts house should have some really
> nice skid plates that should help.  
> Make sure to have good entry speed going into steep
> driveways that flatten out abruptly and you should
> be fine.
>  
> ---
>  
> 4 inches clearance sounds wrong.   I had a buddy
> that had a lowered muscle car with a deep oil pan. 
> The state had done some asphalt grinding and had
> left a very sharp transition on an offramp.  As he
> went from graded to untouched pavement, there was a
> 2-3" abrupt rise, and he left the bottom of his oil
> pan at the edge.  The state shrugged its shoulders
> at him when he tried to make a claim.  
>  
> 4 inches is without any compression of your
> suspension?....  I'd try to tuck everything above
> the frame rails or whatever you have under there. 
> The engineers have to assume that someone will
> highside the car on something, and having junk
> hanging down is normally not done from the factory,
> I should think, so I'd continue to look for some
> sort of pacaging trickery to avoid having things
> dangling down there.
> 
> Impeiral Margarine has a crappy, low-hanging dual
> exhaust that some previous yo-yo put in there, and I
> always cringe when it manages to scritch on
> something, even with the relatively high stock
> clearance of the car.  I feel your pain.
>  
>  
> Keep looking.
>  
>  
>  
> -Kenyon
>  
> 
> Jim Gathmann <jim_gathmann@xxxxxxxxx> wrote:
> When does one know how much clearance is not enough
> clearance on a car without driving it over stuff and
> causing damage?
> 
> Here's my problem- my Dynasty has ~7" clearance
> normally- if measuring from the road up to the
> k-rails
> or the bottom of the OEM exhaust pipes. That 7"
> number
> is about 8.5" if going from the road to the floor
> boards or rockers.
> 
> With my new exhaust system, I have to have two cats-
> which won't fit in the exhaust "groove" in the floor
> boards- and my piping has to cross the k-rails.
> Naturally I can't cut into the krails for this, so
> now
> I'd have ~4" of clearance. Is this too little?
> 
> __________________________________
> Do you Yahoo!?
> The New Yahoo! Search - Faster. Easier. Bingo.
> http://search.yahoo.com
> 
> 
> ----------------- http://www.imperialclub.com
> -----------------
> This message was sent to you by the Imperial Mailing
> List. Please 
> reply to mailing-list@xxxxxxxxxxxxxxxx and your
> response will be 
> shared with everyone. Private messages (and
> attachments) for the
> Administrators should be sent to
> webmaster@xxxxxxxxxxxxxxxx
> To UN-SUBSCRIBE, go to
> http://imperialclub.com/unsubscribe.htm
> 
> 
> ---------------------------------
> Do you Yahoo!?
> The New Yahoo! Search - Faster. Easier. Bingo. 

=====


http://mobile.yahoo.com.au - Yahoo! Mobile
- Check & compose your email via SMS on your Telstra or Vodafone mobile.