Re: poly freeze plug installation

[Gary Pavlovich <glpavlovich@xxxxxxx>]

[AD removed for archives]
-------------------------------------------------------------------
Amazing Diet Patch
The fastest - Easiest way to lose weight! Try it now FREE!
caacYkHbOk33ra/MyDietPatches
-------------------------------------------------------------------

Houston,
The convex side is facing out (towards you - like the hubcaps on your car). 
Use Permatex #3 in the block circle/"hole" (non-hardening nasty stuff like 
they use for water pumps...) and place the freeze plug in the "hole" and tap 
it w/hammer enough to dimple the center; enough that it presses into the 
circle of the block for a tight seal but not so hard that it distorts and 
loosens.   A few small taps around the perimeter of the freeze plug may be 
needed if the blow was excessive, but try to seal it permanently w/the 
center hammer strike.

Take care and let me know how it goes.

Happy New Year to you and your family!
Gary
----- Original Message ----- 
From: <HoustonDB@xxxxxxx>
To: <1962to1965mopars@xxxxxxxxxx>
Sent: Saturday, January 01, 2005 10:35 AM
Subject: poly freeze plug installation


[AD removed for archives]
-------------------------------------------------------------------
Get a Holy Bible for FREE!
caacYkCb7MlEoa/PermissionData
-------------------------------------------------------------------


Getting ready to install the dish style freeze plugs in my poly 318.   My
question is what side of the "dish" faces out?  I've heard the correct 
method
for installation is to drive the plug in, then rap it once in the  center. 
That
just seems like it will drive the plug in deeper.  So  any explanations 
would
be greatly appreciated.

Houston
'64 Belvedere

[Non-text portions of this message have been removed]

[AD removed for archives]
-------------------------------------------------------------------
We can reduce your unsecured credit card debt by 40-60%.
Don't file bankruptcy.  Be Debt Free in as little as 1 year. Take
control of your situation.  100% FREE Consultation.
caacYksb7MlEof/KnockOutDebt
-------------------------------------------------------------------

----
Please address private mail -- mail of interest to only one person --  
directly to that person.  I.e., send parts/car transactions and negotiations 
as well as other personal messages only to the intended recipient, not to 
the Clubhouse public address. This practice will protect your privacy, 
reduce the total volume of mail and fine tune the content signal to Mopar 
topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html.

[AD removed for archives]
-------------------------------------------------------------------
** Get Your Own Support-a-Cure Yellow Bracelet for $1.99 **   
Show your support for finding cures for both AIDS & Cancer. 
Get yours for just $1.99. This bracelet makes a difference.
caacYkkbOk33rf/Penn Media
-------------------------------------------------------------------

----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html. 


bOk33r.