Re: Rear end advice

[Jimmy Peavy <peaver63@xxxxxxxxxxxxxx>]

No you're not going to find a sure grip, in a popular ratio, for $100.
But you can find complete housings with non suregrips for $100.
I just had a Dana 60 narrowed (for more tire space), with a new gear, 
new axles, powdercoated.
I bet I have $1500 or more in those mods.
And I had the Dana to start with. 
You're better off  starting with a rear that doesn't need to be narrowed 
from the start. From a cost factor, I mean.

   Jimmy

Terry Dyke wrote:

> Jimmy you can get 8 3/4 posi rear-ends that are the same width as a 64 
> B body original rear-end for $100.00? If you run into one in 389 or 
> 410 let me know it will save me alot of problems. Most of the 8 3/4 
> rears I find are too wide for the early B bodys. I am just learning on 
> this car so I appriciate all the help I can get. The older parts are 
> far and few between in my area. Terry


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html. 

This email was sent to: arc.6265@xxxxxxxxxxxxxx

. 



http://www/?p=