RE: Carb spacer question

[Brian Schlump <jsbs@xxxxxxxxxxxxx>]

Richard, 
I've had good results with the phenolic spacer on a 440 engine...Brian

Richard Kinsley wrote:
> 
> 
> 
> Rich Kinsley  '64 Polara 4 dr 318poly w/goodies
> 
> I have noticed that the Eddy 500cfm carbs on my Weiand WPD4D manifold 
> with 1" swirl torque aliminum spacers get almost too hot to touch. I'm 
> wondering if the phenolic spacers would be better to help prevent the 
> heat transfer. There are gaskets top and bottom on the spacer but 
> apparently that isn't enough too prevent the heat. 
> 
> What are your thoughts????



'64 Belvedere
Davenport, Iowa

"The difference between ordinary and extraordinary is that little 
extra."


----
Please address private mail -- mail of interest to only one person -- directly to that person.  I.e., send parts/car transactions and negotiations as well as other personal messages only to the intended recipient, not to the Clubhouse public address. This practice will protect your privacy, reduce the total volume of mail and fine tune the content signal to Mopar topic.  Thanks!

'62 to '65 Mopar Clubhouse Discussion Guidelines:
http://www.1962to1965mopar.ornocar.org/mletiq.html.